hex-bifilar-coil

command
v0.0.6 Latest Latest
Warning

This package is not in the latest version of its module.

Go to latest
Published: Jan 21, 2023 License: Apache-2.0 Imports: 9 Imported by: 0

README

Hex (6-layer) bifilar coil

This is a design of a hex bifilar coil, meaning that when this design is fabricated on a six-layer printed circuit board (PCB), there will be six bifilar coils wired in series, one bifilar coil per layer.

The theory is that when you drive the coil with a sine wave at its resonant frequency, it can transfer power at its greatest efficiency.

The beauty of this design is that there are multiple tap points along the length of the coils that result in different resonant frequencies due to the varying reactance. Thus, if your electronics drive the coils properly from the different tap points, this single coil design can potentially support the optimal energy transfer of multiple frequencies.

Another experiment to try is to ground the second tap from the end, drive the end tap with a sine wave at the resonant frequency of the remainder of the coil, and then get the amplified benefits of the remainder as in a secondary coil of a transformer.

How it is wired

All coils are concentric and wind in the same direction. Therefore the magnetic field from each coil section combines uniformly with the other coils resulting in a stronger, cohesive field.

Here is a diagram showing how it is wired:

hex-bifilar-coil-diagram

This shows the various layers on a small (n=12) coil to highlight the wiring and various layers of the PCB:

hex-bifilar-coil-layers

Parametric design

In this design, coils can be created with varying trace widths, gaps between traces, and number of spirals per coil. As a result, this parametric design could theoretically be used for coils of any manufacturable size (from microscopic on up).

Example coils

In this section, we will document emperically-measured resistances and resonant frequencies of fabricated coils as they become available.

Coil 1

hex-bifilar-coil-1.jpg

IMG_20190608_193011.jpg

Coil 1 consists of:

PCB thickness = 1.6mm
trace width = 0.15mm (6 mils)
gap width = 0.15mm
number of coils per spiral = 100
From point To point DC resistance (Ω) Resonant Frequency
3L BL/4L 496
BL/4L TL/5L 130.8 ?
TL/5L 3R/2L 496
3R/2L 4R/BR 496
4R/BR 5R/TR 130.8 ?
5R/TR 2R 496
3L 2R 2230 ~10kHz

Enjoy!


License

Copyright 2019 Glenn M. Lewis. All Rights Reserved.

Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at

http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.

Documentation

Overview

hex-bifilar-coil creates Gerber files (and a bundled ZIP) representing six bifilar coils (https://en.wikipedia.org/wiki/Bifilar_coil) (one on each layer of a six-layer PCB) for manufacture on a printed circuit board (PCB).

Jump to

Keyboard shortcuts

? : This menu
/ : Search site
f or F : Jump to
y or Y : Canonical URL