folie

Folie v1

The Forth Live Explorer is a serial terminal interface for Mecrisp Forth:

• connects as terminal console to an attached microcontroller board over serial
• can also connect to a telnet socket or to ssh, launched as a subprocess
• line entry: each line is sent out after a return, and output displayed back
• command history: uses readline to edit and re-send previous commands
• include files: each line of the form "include <filename>" is processed
  as a request to send the contents of that file as if it had been typed in
• nested includes: include lines found inside are processed recursively
• throttling: each line waits for an "ok." prompt before sending the next one
• firmware uploads: allows erasing an STM32F1 chip and uploading new firmware
• the default baud rate is 115200, see folie -help for a list of options

Note: there's a new Folie v2 in development (work-in-progress for now).

Installation

The latest binaries can be found in the release area on GitHub.
Alternately, get the source code and run make app from tools/folie/.

Windows

Download, uncompress, and rename to "folie.exe".
Launch as "folie -p COM3", assuming the board is connected to COM3.

Warning: the Prolific PL2303 USB serial adapters may not work... (TODO)

Mac OSX

Download, uncompress, rename to "folie", and do a "chmod +x folie".
Launch as "./folie -p /dev/cu.SLAB_USBtoUART" or whatever the device name is.

Linux

Download, uncompress, rename to "folie", and do a "chmod +x folie".
Launch as "./folie -p /dev/ttyAMA0" or whatever the device name is.

Keyboard shortcuts

• return - send command to remote µC
• ctrl-a - go to start of line
• ctrl-e - go to end of line
• up-arrow, ctrl-p - previous command in history
• down-arrow, ctrl-n - next command in history
• ctrl-r / ctrl-s - backward / forward history search
• ctrl-c, ctrl-d - exit Folie

See the readline page for a complete list of all the supported shortcuts.

Connecting to a telnet socket

This mode can be used in combination with an ESP-Link WiFi to serial
bridge, by replacing the serial device name with "<dns-or-ip>:23".

Connecting via SSH

To run Folie as front-end for a Linux-based version of Mecrisp, use the
following incantation: "folie -x ssh <hostname> <path/to/mecrisp>".

On Linux, this same -x option can also be used to launch Mecrisp locally,
using: "folie -x <path/to/mecrisp>".

Firmware uploads

When started with the -u option, Folie will try to upload a firmware image
into an STM32F103 chip, using its built-in boot ROM protocol. For example:

folie -p <port> -u mecrisp-stellaris-stm32f103.bin

To use this mode, the chip needs to be placed in "boot mode", i.e. reset with
the BOOT0 pin tied high (this differs for each board, it's often a jumper).
Note that the chip's flash contents will be completely erased and replaced!

When done: restore the jumper, press reset, and re-launch without -u flag.

Known problems

The last output line(s) can get overwritten when using history search.
Under Windows, Prolific PL2303 chips are causing deadlocks - no idea why.

License

MIT, see also chzyer/readline and tarm/serial included in this app.