inhooks

Inhooks

Inhooks aims to be a lightweight incoming webhooks gateway solution. Written in Go and runnable as a single binary or docker container. Only requires a redis database for storage/queueing.

You can read more about inhooks in the launch blog post.

Note: This software is still early in its development cycle / not battle-tested. Test thoroughly before using in production systems.

Architecture

High level overview

Inhooks listens to HTTP webhooks and saves the messages to Redis. A processing module retrieves the messages and sends them reliably to the defined targets.

Features

• Receive HTTP Webhooks and save them to a Redis database
• Fanout messages to multiple HTTP targets
• Fast, concurrent processing
• Supports delayed processing
• Supports retries on failure with configurable number of attempts, interval and constant or exponential backoff
• Supports different HTTP payloads types: JSON, x-www-form-urlencoded, multipart/form-data
• ... more features planned

Usage

Inhooks config

The inhooks config file allows setting up the Source to Sink flows. Create a file named inhooks.yml in the folder where the inhooks server will run (configurable via the INHOOKS_CONFIG_FILE env variable).

Example inhooks.yml config

flows:
  - id: flow-1
    source:
      id: source-1
      slug: source-1-slug
      type: http
    sinks:
      - id: sink-1
        type: http
        url: https://example.com/target
        delay: 90s # delay processing by 90 seconds
      - id: sink-2
        type: http
        url: https://example.com/othertarget
        retryInterval: 5m # on error, retry after 5 minutes
        # retryExpMultiplier: 2 # exponential backoff
        maxAttempts: 10 # maximum number of attempts

With this config, inhooks will listen to http POST requests to /api/v1/ingest/source-1-slug.

When a message is received, it is saved to the redis database. Then inhooks tries to send it to each of the urls defined in the sinks section of the config. In case of failures, retries are attempted based on the sink config params.

If the config is modifed, the server must be restarted to load the new config.

Securing webhooks

If you would like to verify your webhooks with HMAC 256, you can use the following configuration:

flows:
  - id: flow-1
    source:
      id: source-1
      slug: source-1-slug
      type: http
      verification:
        verificationType: hmac # only option supported at the moment
        hmacAlgorithm: sha256 # only option supported at the moment
        signatureHeader: x-my-header # the name of the http header in the incoming webhook that contains the signature
        signaturePrefix: "sha256=" # optional signature prefix that is required for some sources, such as github for example that uses the prefix 'sha256='
        currentSecretEnvVar: VERIFICATION_FLOW_1_CURRENT_SECRET  # the name of the environment variable containing the verification secret
        previousSecretEnvVar: VERIFICATION_FLOW_1_PREVIOUS_SECRET # optional env var that allows rotating secrets without service interruption

Development setup

Tools

Go 1.20+ and Redis 6.2.6+ are required

Install tools

make install-tools

Env

Copy the .env examples to init the .env files

cp .env.example .env
cp .env.test.example .env.test

Run tests

make test

Run linter

make lint

Run Dev Server

make run-dev

Run Docker Compose

docker-compose up

Contributing

Feel free to open new issues or PRs ! You can also reach out to the maintainer at the email address: adil-inhooks@ledidil.com

License

Copyright (c) 2023 Adil H.

Inhooks is an Open Source project licensed under the terms of the LGPLv3 license. Please see LICENSE for the full license text.