cmd-nse-remote-vlan

Intro

This repo contains 'nse-remote-vlan' an NSE application for Network Service Mesh. It provides ipam and vlan configuration context for registered Network Services.

Usage

nse-remote-vlan accept following environment variables:

• NSM_NAME Name of the endpoint
• NSM_CONNECT_TO An URL of registry service to connect to
• NSM_MAX_TOKEN_LIFETIME Maximum lifetime of tokens
• NSM_CIDR_PREFIX CIDR Prefix to assign IPs from
• NSM_IPV6_PREFIX Ipv6 Prefix for dual-stack
• NSM_REGISTER_SERVICE if true then registers network service on startup
• NSM_LISTEN_ON tcp:// url to be listen on. It will be used as public to register NSM
• NSM_SERVICES List of supported services

Build

Build cmd binary locally

You can build the locally by executing

go build ./...

Build Docker container

You can build the docker container by running:

docker build .

Testing

Testing Docker container

Testing is run via a Docker container. To run testing run:

docker run --privileged --rm $(docker build -q --target test .)

Debugging

Debugging the tests

If you wish to debug the test code itself, that can be acheived by running:

docker run --privileged --rm -p 40000:40000 $(docker build -q --target debug .)

This will result in the tests running under dlv. Connecting your debugger to localhost:40000 will allow you to debug.

-p 40000:40000

forwards port 40000 in the container to localhost:40000 where you can attach with your debugger.

--target debug

Runs the debug target, which is just like the test target, but starts tests with dlv listening on port 40000 inside the container.

Debugging the cmd

When you run 'cmd' you will see an early line of output that tells you:

Setting env variable DLV_LISTEN_FORWARDER to a valid dlv '--listen' value will cause the dlv debugger to execute this binary and listen as directed.

If you follow those instructions when running the Docker container:

docker run --privileged -e DLV_LISTEN_FORWARDER=:50000 -p 50000:50000 --rm $(docker build -q --target test .)

-e DLV_LISTEN_FORWARDER=:50000 tells docker to set the environment variable DLV_LISTEN_FORWARDER to :50000 telling dlv to listen on port 50000.

-p 50000:50000 tells docker to forward port 50000 in the container to port 50000 in the host. From there, you can just connect dlv using your favorite IDE and debug cmd.

Debugging the tests and the cmd

docker run --privileged -e DLV_LISTEN_FORWARDER=:50000 -p 40000:40000 -p 50000:50000 --rm $(docker build -q --target debug .)

Please note, the tests start the cmd, so until you connect to port 40000 with your debugger and walk the tests through to the point of running cmd, you will not be able to attach a debugger on port 50000 to the cmd.